Category. Anthelminthic.

Storage. Pyrantel tablets should be kept in a tight, lightly-closed container, protected from light.

Labelling. The designation on the container of Pyrantel tablets should state that the active ingredient is in the embonate form and the quantity should be indicated in terms of equivalent amount of pyrantel.

Requirements

Comply with the monograph for Tablets.

Definition. Pyrantel tablets contain Pyrantel embonate. They contain not less than 90.0% and not more than 110.0% of the amount of pyrantel (C₁₁H₁₄N₂S) stated on the label.

Identity tests

• Either test A alone or any two of tests B, C and D may be applied.

To a quantity of the powdered tablets containing the equivalent of about 20 mg of pyrantel add a mixture of 10 mL of dichloromethane R, 10 mL of methanol R and about 1 mL of ammonia (~260 g/L) TS, shake and filter. Evaporate the filtrate to dryness on a water-bath, dissolve the residue in a small volume of methanol R (about 3 mL) by heating on a water-bath and then allowing the solution to cool. Separate the crystals, dry at 80 °C for 2 hours and use the dried crystals for the "Identity tests A and C”.

A. Carry out the examination with the dried crystals as described under 1.7 Spectrophotometry in the infrared region. The infrared absorption spectrum is concordant with the spectrum obtained from pyrantel embonate RS treated similarly or with the reference spectrum of pyrantel embonate.

B. See the test described below under “Related substances”, method A. The two principal spots obtained with solution (1) correspond in position, appearance and intensity with those obtained with solution (3).

C. The absorption spectrum (1.6) of a 13 μg/mL solution of the dried crystals in methanol R, when observed between 230 nm and 360 nm, exhibits 2 maxima at about 288 nm and 300 nm. The ratio of the absorbance at 288 nm to that at 300 nm is about 1.0.

D. See the test described under “Assay”. The retention times of the principal peaks in the chromatogram obtained from solution (1) are similar to those obtained from solution (2).

Dissolution

Carry out the test as described under 5.5 Dissolution test for solid oral dosage forms using as the dissolution medium 900 mL of a solution prepared by dissolving 1.0 g of sodium dodecyl sulfate R and 7 mL hydrochloric acid (~420g/L) TS in 1000 mL of water. Rotate the paddle at 75 revolutions per minute. At 60 minutes withdraw a sample of 10 mL of the medium through an in-line filter. Transfer 1.0 mL of the clear filtrate to a 50 mL volumetric flask and dilute to volume with hydrochloric acid/methanol (0.1 mol/L) TS (solution (1)). For solution (2) transfer about 20 mg of pyrantel embonate RS (equivalent to about 7.0 mg of pyrantel), accurately weighed, into a 25 mL volumetric flask. Add about 10 mL of dimethylformamide R, shake to dissolve and dilute to volume with hydrochloric acid/methanol (0.1 mol/L) TS. Transfer 1.0 mL of this solution to a 50 mL volumetric flask and dilute to volume with hydrochloric acid/methanol (0.1 mol/L) TS . Measure the absorbance (1.6) of the samples at a wavelength of 316 nm using hydrochloric acid/methanol (0.1 mol/L) TS as the blank.

For each of the tablets tested calculate the total amount of pyrantel (C₁₁H₁₄N₂S) in the medium from the absorbances obtained using the declared content of C₁₁H₁₄N₂S,C₂₃H₁₆O₆ in pyrantel embonate RS. Each mg of pyrantel embonate C₁₁H₁₄N₂S,C₂₃H₁₆O₆ is equivalent to 0.3469 mg of pyrantel C₁₁H₁₄N₂S. Use the requirements as described under 5.5 Dissolution test for solid oral dosage forms, Acceptance criteria to evaluate the results: the amount in solution is not less than 70% (Q) of the amount declared on the label.

Related substances

Carry out the operations in subdued light and without any prolonged interruptions, preferably using low-actinic glassware.

• Either method A or B may be applied.

A. Carry out the test as described under 1.14.1 Chromatography, Thin-layer chromatography using silica gel R6 as the coating substance and a mixture of 3 volumes of ethyl acetate R, 1 volume of water R and 1 volume of glacial acetic acid R as the mobile phase.

Prepare the following solutions. For solution (1) add to a quantity of the powdered tablets equivalent of about 35 mg of pyrantel a mixture of 10 mL of dichloromethane R, 10 mL of methanol R and about 1 mL of ammonia (~260 g/L) TS, shake and filter. Evaporate the filtrate to dryness on a water-bath and dissolve the dried residue in 10.0 mL dimethylformamide R. For solution (2) dilute 1.0 mL of solution (1) to 100 mL with dimethylformamide R. For solution (3) use 10 mg of pyrantel embonate (RS) (equivalent to about 3.5 mg of pyrantel) per mL dimethylformamide. For solution (4) expose a quantity of solution (3) under 2000 lux illumination for 24 hours. Alternatively use 10 mg of pyrantel embonate impurity A RS and 2 mg of pyrantel embonate RS (equivalent to about 0.7 mg of pyrantel) per mL dimethylformamide R for solution (4).

Apply separately to the plate 5 μL of each of the solutions (1), (2) and (4).

After application allow the spots to dry for 15 minutes in a current of air. Develop over a path of 12 cm. After removing the plate from the chromatographic chamber allow it to dry in a current of air for 10 minutes. Examine the chromatogram in ultraviolet light (254 nm).

Pyrantel and related substances have the following R_f values: impurity A about 0.2; pyrantel about 0.3; embonic acid about 0.9. The test is not valid unless the chromatogram obtained with solution (4) exhibits three well-separated spots.

In the chromatogram obtained with solution (1) any spot corresponding to impurity A is not more intense than the pyrantel spot in the chromatogram obtained with solution (2) (1.0 %).

B. Carry out the test as described under 1.14.1 Chromatography, High-performance liquid chromatography using the conditions given under “Assay”.

Prepare the following solutions. For solution (1) weigh and powder 20 tablets and transfer a quantity containing the equivalent of about 25 mg of pyrantel into a 100 mL volumetric flask. Add 7 mL of a mixture composed of 5 volumes of glacial acetic R, 5 volumes of water R and 2 volumes of diethylamine R. Shake and dilute to volume with acetonitrile R, mix and filter. For solution (2) dilute 1.0 mL of the solution (1) to 100.0 mL with mobile phase. For solution (3) expose 10 mL of solution (1) under 2000 lux illumination for 24 hours. Alternatively transfer 10 mg of pyrantel embonate impurity A RS to a 10.0 mL flask, add 8 mL of solution (1) and make up to volume with dimethylformamide R to obtain solution (3).

Inject separately 20 μL each of solution (1), (2) and (3) and record the chromatogram for solution (1) for 4 times the retention time of pyrantel.

In the chromatogram obtained with solution (3) the following peaks are eluted at the following relative retention with reference to pyrantel (retention time about 14 minutes): embonic acid about 0.5; impurity A about 1.3. The test is not valid unless the resolution factor between the pyrantel peak and the impurity A peak is at least 4.0.

In the chromatogram obtained with solution (1) the area of any peak corresponding to impurity A is not greater than the area of the pyrantel peak obtained with solution (2) (1.0 %).

Assay

The operations described below must be carried out in subdued light and without any prolonged interruptions, preferably using low-actinic glassware.

Carry out the test as described under 1.14.1 Chromatography, High-performance liquid chromatography using a stainless steel column (25 cm × 4.6 mm) packed with high-purity base particles of silica gel for chromatography R (5 μm).

As the mobile phase use a mixture of 92.8 volumes of acetonitrile R and 7.2 volumes of a solvent mixture composed of 5 volumes of glacial acetic R, 5 volumes of water R and 2 volumes of diethylamine R.

Prepare the following solutions. For solution (1) weigh and powder 20 tablets. Transfer a quantity of the tablets containing the equivalent of about 7.0 mg of pyrantel, accurately weighed, into a 50 mL volumetric flask. Add about 30 mL of mobile phase, shake for 10 minutes and dilute with mobile phase to volume, mix and filter. Transfer 2.0 mL of the clear filtrate to a 10 mL volumetric flask, dilute with mobile phase to volume and mix. For solution (2) prepare a solution of 0.40 mg of pyrantel embonate RS (equivalent to about 0.14 mg of pyrantel) per mL mobile phase. Transfer 2.0 mL of this solution to a 10 mL volumetric flask, dilute with mobile phase to volume and mix to obtain a standard preparation having a known concentration of 80 μg of pyrantel embonate RS (equivalent to about 28 μg of pyrantel) per mL.

Operate with a flow rate of 1.0 mL per minute. As a detector use an ultraviolet spectrophotometer set at a wavelength of about 288 nm.

Inject separately 20 μL each of solution (1) and (2) and record the chromatograms.

In the chromatogram obtained with solution (2) the peak due to embonic acid is eluted at a relative retention of about 0.5 with reference to pyrantel (retention time about 14 minutes).

Measure the areas of the peak responses due to pyrantel obtained in the chromatograms from solution (1) and solution (2) and calculate the content of pyrantel (C₁₁H₁₄N₂S) in the tablets using the declared content of C₁₁H₁₄N₂S,C₂₃H₁₆O₆ in pyrantel embonate RS. Each mg of pyrantel embonate C₁₁H₁₄N₂S,C₂₃H₁₆O₆ is equivalent to 0.3469 mg of pyrantel C₁₁H₁₄N₂S.

Impurities

A. 1-methyl-2-[(1Z)-2-(thiophen-2-yl)ethenyl]-1,4,5,6-tetrahydropyrimidine.